24
Setting the ATW-DT3101/ATW-DT3102
Adjusting the microphone input gain
1. From the menu screen, press the UP/DOWN button to select
[GAIN], and then press the SET button.
0dB
GAIN
2. Press the UP/DOWN button to select the gain you wish to set.
• The level changes by 2dB each time you press the UP/DOWN button.
• It can be set to a value from −10 to +20dB.
3. Press the SET button.
• The setting is complete.
Setting the connection of the input connector
(only for the ATW-DT3101)
Set the device connected to the input connector of the transmitter to
[MIC] (microphone) or [INST] (guitar cable, etc.).
1. From the menu screen, press the UP/DOWN button to select
[INPUT], and then press the SET button.
2. Press the UP/DOWN button to select [Mic] or [Inst].
3. Press the SET button.
• The setting is complete.
Selecting the microphone input gain (only for
the ATW-DT3101)
1. From the menu screen, press the UP/DOWN button to select
[SENSITIVITY], and then press the SET button.
0dB
SENSITIVITY
2. Press the UP/DOWN button and select [0dB] or [+10dB].
3. Press the SET button.
• The setting is complete.
Setting the RF transmission output
1. From the menu screen, press the UP/DOWN button to select
[RF POWER], and then press the SET button.
High:20mW
RF POWER
2. Press the UP/DOWN button to select the RF transmission output
from [High:20mW], [Mid:10mW], and [Low:2mW].
3. Press the SET button.
• The setting is complete.
Setting the HPF (High-Pass Filter)
1. From the menu screen, press the UP/DOWN button to select
[HPF], and then press the SET button.
O
HPF
2. Press the UP/DOWN button to select [Off], [80Hz], [120Hz], or
[160Hz].
3. Press the SET button.
• The setting is complete.
Setting the lock
1. From the menu screen, press the UP/DOWN button to select
[LOCK], and then press the SET button.
Unlock
LOCK
2. Press the UP/DOWN button to select [Lock] or [Unlock].
Lock Locks transmitter buttons
Unlock Unlocks transmitter buttons
3. Press the SET button.
• The setting is complete.
To Next Page
Loading...
Need help?
General
