EasyManuals Logo

Audio Technica AT-LP140XP User Manual

Audio Technica AT-LP140XP
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
Preparation for use
Installing/removing the dust cover
The dust cover is designed to protect the product’s sensitive
components when the product is not in use. It should remain off
while records are playing.
Using the dust cover during play may result in record damage or
sound degradation.
Always remove and replace the dust cover carefully.
Connecting to connectable equipment (active
speakers, amplifiers, etc.)
Connect the RCA audio cable to an input jack that is compatible with
the connectable equipment you are using (amplifier, receiver, active
speakers, sound card, etc.).
The RCA audio cable’s red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
* Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.
Connecting the power cable
Finally, after all audio connections are made, attach the included
power cable to the product. Then connect the power cable plug to a
convenient AC outlet.
PHONO
L R
With PHONO input*
To outlet
To outlet
Connectable
equipment
(amplifier, etc.)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audio Technica AT-LP140XP and is the answer not in the manual?

Audio Technica AT-LP140XP Specifications

General IconGeneral
TypeDirect drive DJ turntable
OperationManual
Motor typeDC motor
Brake systemElectronic brake
Pitch controlYes
Wow & flutter0.2 %
Nominal speeds33 1/3, 45, 78 RPM
Starting torque2.2 kg/cm
Motor brush typeBrushless
Number of speeds3
Pitch control range-8 - 16 %
Signal-to-Noise Ratio (SNR)50 dB
Product colorSilver
Platter materialAluminum
USB port-
AC input voltage115 - 230 V
AC input frequency50 - 60 Hz
Power consumption (typical)4.3 W
ShapeS-shaped tonearm
Overhang16 mm
Tonearm typeStatically balanced tonearm
Tracking angle3 °
Stylus pressure6.2 g
Anti-skating range0 - 4 g
Cables includedRCA/GND
Weight and Dimensions IconWeight and Dimensions
Weight10000 g

Related product manuals