8
Specications
Communication system
Bluetooth
Ver. 3.0
Output
Bluetooth
Specification Power Class 2
Maximum communication range Line of sight - approx. 10m
Compatible Bluetooth profile A2DP
Support codec SBC
Type Belt drive turntable, fully automatic
Platter Aluminum
Motor DC servo-controlled
Speeds 33
1
/
3
RPM, 45 RPM
Wow and flutter Less than 0.25% (WTD) @ 3 kHz (JIS)
Signal-to-noise ratio >50 dB (DIN-B)
Cartridge Integral Dual Moving Magnet
™
stereo cartridge with diamond stylus
Output level
Pre-amplifier “PHONO” 2.5 mV nominal at 1 kHz, 5 cm/sec
Pre-amplifier “LINE” 150 mV nominal at 1 kHz, 5 cm/sec
Phono pre-amplifier gain 36 dB nominal, RIAA equalized
Power 220 to 240V AC, 50/60 Hz, 3W (Europe)
Dimensions 360.0 mm (14.17") W x 97.5 mm (3.84") H x 356.0 mm (14.2") D
Net weight 2.98 kg (6.6lbs.)
Accessories 3.5 mm (1/8") mini-plug (male) to dual RCA (male) stereo output cable, 45 RPM adapter, Removable hinged
dust cover
Replacement stylus ATN3600L
• The
Bluetooth
word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Audio-Technica Corporation is under license.
All other trademarks are property of their respective owners.
• For product improvement, the product is subject to modification without notice.
Tips For Better Performance
• When opening or closing the turntable cover, handle it gently,
moving it either at the center or equally from both sides.
• Do not touch the stylus tip with your fingers; avoid bumping
the stylus on the turntable mat or a record’s edge.
• Clean the stylus tip frequently, using a soft brush with a
back-to-front motion only.
• If you use a stylus cleaning fluid, use it very sparingly.
• Wipe the dust cover and turntable housing gently with a soft
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
• Never apply harsh chemicals or solvents to any part of the
turntable system.
• Prior to moving the turntable, always unplug it from the AC
outlet and fasten the tone arm on the tone arm rest with the
vinyl twist-tie.
Specications