Specifications
Turntable (AT-LP60XHP)
Type Belt-drive, fully automatic
operation
Motor DC servo-controlled
Speeds 33-1/3 RPM, 45 RPM
Turntable platter Aluminum
Wow and flutter < 0.25% (WTD) at 3 kHz
Signal-to-noise ratio > 50 dB (DIN-B)
Cartridge Type VM
Outputs levels
“PHONO”
“LINE”
2.5 mV nominal at 1 kHz,
5 cm/sec
150 mV nominal at 1 kHz,
5 cm/sec
Phono pre-amp gain 36 dB nominal, RIAA equalized
Power supply requirements 100 to 240 V, 50/60 Hz, 0.6 A
Max.
Power consumption 1.9 W
AC adapter 12 V, 2 A
Dimensions 359.5 mm (14.15") x 97.5 mm
(3.84") x 373.3 mm (14.70")
(W x H x D)
Weight 2.7 kg (5.95 lbs)
Accessories Dust cover, Felt mat, Platter
(with drive belt), 45 RPM
adapter, RCA audio cable
(approx. 1.2 m (3.9')), AC
adapter (approx. 1.5 m (4.9'))
Replacement stylus (sold
separately)
ATN3600L
Replacement belt (sold
separately)
AT-LP60X exclusive belt
Headphones (ATH-250AV)
Type Closed-back dynamic
Driver 40 mm
Sensitivity 102 dB/mW
Frequency response 18 to 22,000 Hz
Maximum input power 500 mW
Impedance 43 ohms
Weight (without cable) 97 g (3.4 oz)
Cable length 3.5 m (11.5')
Plug 3.5 mm (⅛") gold-plated stereo
mini-plug
Sold separately Earpads
Specifications are subject to change without notice due to
improvements.
Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan
www.audio-technica.com
©2019 Audio-Technica Corporation
Global Support Contact: www.at-globalsupport.com
162501373-02-01 ver.1 2019.05.15
To Previous Page
Loading...
