EasyManuals Logo
Home>Audio Technica>Microphone system>AT2020USB-X

Audio Technica AT2020USB-X User Manual

Audio Technica AT2020USB-X
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3
Notes on use
Be sure to read the connected device’s user manual before use.
When the product is used for a long time, the product may become discolored due to ultraviolet light (especially
direct sunlight) and wear.
Use the included USB cable for connection.
Make sure to hold the plug when connecting and disconnecting the USB cable. The USB cable may become severed
or an accident may occur if you pull on the USB cable itself.
When using the USB cable, be careful not to twist it to prevent damage to the USB cable.
Do not wind the USB cable at the base of the plug to prevent a disconnection.
Do not use a USB hub or USB extension cable.
When plugging the USB cable into the microphone and the connected device, check that the connector is facing in
the correct direction before inserting it straight. Inserting the plug diagonally may cause a malfunction.
When not in use, disconnect the USB cable from the product.
Make sure that no foreign matter enters inside the mesh part of the product. Performance may be degraded.
Depending on the surface treatment of the table on which the product is installed, the desk stand may leave marks
on the table.
For important recordings, perform a trial recording beforehand to make sure that the sound is recorded correctly.
Operation is not guaranteed with all computers.
Operation cannot be guaranteed in a home-built computer, personal OS upgrade, or multi-boot environment.
Audio
-Technica will not be liable in any way for any loss or damage to
software or data connected to the product.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audio Technica AT2020USB-X and is the answer not in the manual?

Audio Technica AT2020USB-X Specifications

General IconGeneral
Cable length2 m
Control typeButtons, Rotary
Plug and PlayYes
Product colorBlack
Windows operating systems supportedWindows 10, Windows 11, Windows 8.1
Power sourceUSB
Input voltage5 V
Device interface3.5 mm (1/8\
USB connector typeUSB Type-C
Connectivity technologyWired
Cables includedUSB Type-C to USB Type-A
Number of products included1 pc(s)
TypePC microphone
Bit rate24 bit
Sample rate96 kHz
Volume controlRotary
Voice coil typeDynamic
Microphone frequency20 - 20000 Hz
Microphone Total Harmonic Distortion (THD)1 %
Output impedance32 Ω
Weight and Dimensions IconWeight and Dimensions
Height142 mm
Diameter52 mm
Microphone weight373 g

Related product manuals