7
• Fully charge the battery when using it for the first time.
• When the rechargeable battery is running low, the headphones will play a confirmation tone and voice guidance
notifying you of low battery level, and an indicator lamp will flash in red. When you hear/see these notifications, charge
the battery.
• It takes about 3 hours to charge the battery fully. (This time may vary depending on usage conditions.)
1. Connect the included exclusive USB cable (USB Type-C side) to the product’s connector jack.
• The included exclusive USB cable is designed for exclusive use with the product. Do not use other USB cables.
• When inserting the exclusive USB cable into the USB port or connector jack, insert it directly (horizontally).
• Charging in wet conditions should be avoided. Doing so may cause the product to malfunction.
2. Connect the included exclusive USB cable (USB Type-A side) to the computer to start charging.
• While charging, the indicator lamp lights as follows.
Lit in red : Charging in progress
Off : Charging complete
3. When charging is complete, disconnect the exclusive USB cable (USB Type-A side) from the computer.
• When removing the exclusive USB cable, remove the hardware from the computer side first.
4. Remove the exclusive USB cable (USB Type-C side) from the product’s connector jack.
Charging the battery
• If you charge while the product is on, it will turn off. When charging is complete, remove the exclusive USB cable
and turn on the product again.
• When charging, make sure to use the included exclusive USB cable. The product may not charge with cables other
than the included exclusive USB cable.
Computer
Connector jack
USB Type-C
USB Type-A
Exclusive USB cable
(included)
USB port
To Next Page
Loading...
