AudioCodes Mediant 500 - Page 29

Quick Guide 5. Configure Device
Version 7.2 29 AudioCodes Mediant Gateway
5.4 Configure Coders
This step describes how to configure coders (termed Coder Group) per BroadSoft SIP
Trunk requirement.
 To configure coders:
1. Open the Coder Groups table (Setup menu > Signaling & Media tab > Coders &
Profiles folder > Coder Groups).
2. Configure a Default Coder Group:
Parameter Value
Coder Group Name
AudioCodersGroups_0
Coder Name
G.729
Coder Name
G.711A-law
Coder Name
G.711U-law
Figure 5-16: Configuring a Default Coder Group