AudioCodes Mediant 500L - Figure 4-3: Positioning the Devices Anti-Slide Rubber Legs into Shelfs Openings; Figure 4-4: Device Mounted on Shelf in 19-Inch Rack

Media Gateway & E-SBC 19 Mediant 500L
Hardware Installation Manual 4. Mounting the Device
3. Place the device on the shelf so that the device's front panel faces the front of the rack
and the device's four anti-slide rubber legs (located on the bottom of the device) fit into
the four square openings on the shelf, as shown in the figure below (viewed from
underneath):
Figure 4-3: Positioning the Device's Anti-Slide Rubber Legs into Shelf's Openings
4. Make sure the device is firmly mounted on the shelf so it does not horizontally slide in
any direction:
Figure 4-4: Device Mounted on Shelf in 19-inch Rack