Pin Signal Name
5
7
Ethernet signal pair (1000Base-T)
8
Shield
Chassis ground
To connect the device to the LAN:
1. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the LAN port,
located on the rear panel and labeled GE LAN.
Figure 5-2: Cabling LAN Ports
2. Connect the other end of the cable to a network device or entity.
3. For 1+1 LAN protection, repeat steps 1 and 2 for the standby port, but connect it to
another network (but in the same subnet).
Warning: Ethernet port interface cabling must be routed only indoors and must not exit
the building.
To Next Page
Loading...
