AudioCodes Mediant 800 - Configuring the Route on the Lync Server 2010; Figure 4-16: Lync Server Control Panel

Configuration Note 4. Configuring Microsoft Lync Server 2010
Version 1.0 Issue 1.0 27 October 2011
4.3 Configuring the ‘Route’ on the Lync Server 2010
This section describes how to configure a ‘Route’ on the Lync server and associates it
with the IP/PSTN gateway.
¾ To configure the ‘route’ on the Lync server:
1. Open the Communication Server Control Panel (CSCP), click Start, select All
Programs, and select Lync Server Control Panel.
Figure
4-16: Lync Server Control Panel
2. You are prompted for credentials; enter your domain username and password.