Configuration Note 5. Configuring the E-SBC Device
Version 1.0 Issue 1.0 43 October 2011
5.2 Step 2: Enable the SIP SBC Application Mode
This step describes how to enable the gateway-SBC devices’ SIP SBC application
mode.
¾ To enable the SIP SBC application mode:
1. Open the 'Application Enabling' page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
Figure
5-10: Application Enabling
2. From the ‘Enable IP2IP Application’ drop-down list, select “Enable”.
Reset with BURN to FLASH is required.
Note: To enable IP2IP capabilities on the AudioCodes E-SBC device, your
device must be loaded with the feature key that includes the IP2IP
feature and must be running SIP version 6.2 or later.
2
To Next Page
Loading...
