Step 3 – Connecting the Power Cord
1. Verify that the power switch on the left speaker rear panel is in the OFF position.
2. Confirm that the rear panel voltage selector switch is set to the proper voltage for your area.
3. Connect the power cord into the left speaker and the other end into an AC power outlet.
Note:
We recommend using a high-quality surge suppressor and/or AC line filter on all electronics equipment.
Step 4 – Connecting Audio Cables
Using the appropriate audio cable (3.5” mini-jack and/or RCA cable), connect your audio source (computer, iPod,
etc.) to the A5+ audio inputs. One of each cable type is included.
Note:
Both audio inputs on the A5+ are active so two audio sources may be connected to the speakers at the same time
without the need for an input switch.
Step 5 – Operation
1. Move the A5+ rear panel power switch to the ON position. The left speaker front panel power indicator should
flash a few times then go solid.
2. Turn on your audio input source and adjust the volume to the desired listening level.
3. Adjust the A5+ speaker volume level with the volume knob on the front panel or with the included remote
control.
Break-in Period
Your speakers will sound great out of the box and will get better over time. No need to do anything else but listen to
them, but give them at least 30 to 50 hours break-in time before doing any critical listening.
Cleaning
We don’t recommend using any solvents or cleaners on Audioengine cabinets or speakers. Just wipe down with a
soft, dry cloth.
Other Features
To Next Page
Loading...
Need help?
General
Weight and Dimensions
