Step 5 – Operation
Turn on the N22 volume/power knob and set the volume control to an initial setting of about 3 o’clock. The front panel
power indicator will be illuminated. Turn on your audio input source and adjust the volume to your desired listening
level.
Note that both audio inputs on the N22 are active so two audio sources may be connected to the amplifier at the
same time without the need for an input switch. We recommend using the volume control on each audio source to
adjust the overall system volume.
N22 SETUP VIDEO
N22 Troubleshooting Tips
The following troubleshooting tips can help diagnose and correct most concerns with the N22. We have attempted to
make this list as comprehensive as possible. So, even though some of these may not apply to your issue, please still
go through each one.
If the power indicator LED on the N22’s external power supply unit is not on, then try these tips:
1. Connect the AC power cord to the power supply unit and to a working AC power outlet.
2. Plug the cable at the other end of the power supply into the rear of the N22.
If the power supply light is on but you are experiencing an audio-related issue, try these tips:
1. Verify that the volume/power control on the front panel is not all the way down or off.
2. Ensure that your audio source is on and that the volume level is not too low.
3. Check speaker wire connections from the amp to the speakers by removing the speaker wire from each
speaker and then reconnecting. Also check the speaker wire polarity by verifying that the wires are going to
same terminals on both speakers.
4. Unplug and reconnect the cable(s) from your audio source(s) to the amplifier.
5. Try decreasing the volume of the input audio source and increase the volume of the N22 amp.
6. Try using different audio input sources and/or devices to see if the problem follows.
7. Listen with headphones if possible to see if the issue is present there as well.
8. Try swapping your left and right speaker to see if the issue remains in the same channel or if it follows the
speaker.
9. When using the N22 with a computer, make sure the volume is up on your media player, internet radio, master
control, device volume, etc. and that the balance control is centered.
10. If you are using a wireless adapter, preamp, or an external DAC with your N22, remove these (temporarily) and
connect the audio source directly to the speakers.
11. If your input source has its own EQ (equalizer), please make sure the low end is at a moderate level. Too much
bass in your signal can cause some unwanted distortion.
12. Move your N22 and speakers to a different location to see if something is causing interference in the current
setup. Something as simple as a wireless internet router, cordless or mobile phone, or halogen lamp nearby
can cause interference.
Downloads
Audioengine N22 Desktop Amplifier Manual – Download PDF
Related Manuals
1. audioengine HD3 Premium Powered Desktop Speakers Quickstart Guide www.audioengineusa.com Premium
Powered Desktop Speakers Quickstart Guide Welcome to the...
2. Audioengine A2+ Speaker System Manual Audioengine A2+ Setup Guide www.audioengineusa.com Premium Powered
Desktop Speakers Basic...
3. Audioengine A5+ Speaker System Manual Audioengine A5+ Premium Powered Book shelf Speakers Audioengine, Ltd. +...
4. Audioengine B1 Bluetooth Music Receiver Manual Audioengine B1 Premium Bluetooth Music Receiver Introduction
https://manuals.plus/wp-content/uploads/2021/05/N22_How_To.mp4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
