- 8 -
STEP 4
Plug the cord into the wall outlet
a)Before connecting power cord, make
sure the voltage of the unit matches
with your local voltage.
b)Plug the power cord directly into the
nearest wall outlet, and wrap the
remaining cord around the cord
storage knob at the rear of the unit.
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT
CAUTION
TO REDUCE THE RISK OF FIRE, DO NOT PLACE ANY HEATING OR
COOKING APPARATUS BENEATH THIS UNIT.
CAUTION
MOUNTING SUGGESTIONS
1) If your cabinet has obstructions inside it which prevent you from using the template,
cut out the corresponding area on the template, but do NOT cut out or through the
screw holes.
2) If your cabinet has obstructions underneath it, which will interfere with the mounting
of the unit, remove the obstruction before mounting the unit, or find another location
to mount the unit.
3)It is recommended that you wear safety glasses while drilling to prevent eye injuries.
4)For wood cabinets, you may want to mark the hole locations with a nail, pressed gently
but firmly into the wood so that a slight impression is made. This will also help keep
the drill bit centered in the right location.
5) Hold the drill firmly against the cabinet to keep the drill from “walking”.
MOUNTING INSTRUCTIONS
(Continued from previous page)
Figure 8
Spacers
Cabinet
Overhang
Equaltoor
Longer than
Cabinet
Overhang
Cabinet
Bottom
3
8
/
”
Minimum
g) Gently tighten each screw until they
are firmly holding the unit in place. The
top front edge of the unit should clear
the overhang. Go to STEP4.
To Next Page
Loading...
