Audiovox Pursuit PRO-9744 User Manual

Important! The PRO-9744 alarm system is configurated for many different user
preferences. Please read this entire manual to fully understand the operation of
your specific unit's installation.
MODEL PRO-9744
Owner's Manual
Remote Alarm with
Selectable Pre-Load Features
-1-
 2 Four Button Anti Code Grabbing Programmable Transmitters
 6 Channel Code Learning Receiver
 Remote Panic All Modes
 Protected Valet/Manual Override
 8 Function LED- Armed, Disarmed, Arming, Zone 1, Zone 2, Zone 3,
Zone 4, & Valet
 Intrusion Alert With Memory
 Audible Arm, Disarm, Defective Zone, and Tamper Indication
 Instant Siren Activation
 Starter Disable
 True Last Door Arming
 Defective Zone By-Pass
 Hard Wire Switch Sensing
 On Command RF Chirp Delete
 6 Tone Multi-Tone Siren
 Multiple Vehicle Operation
 On Command R.F. Chirp Delete
 R.F. Shock Sensor Delete (optional Dual-Stage Shock Sensor required)
 Active or Passive Arming
 Active or Passive Door Locks
 Ignition Control Door Lock On/Off
 Ignition Control Door Unlock, (Drivers Door or All Doors), On or Off
 Independent RF Headlamp Control
 20 Second Headlight Illumination Arm Or Disarm, Both Or None
 Panic On Lock Button Or On Separate Button
FEATURES & OPTIONS:
SELECTABLE FEATURES:

Audiovox Pursuit PRO-9744 Specifications

General

Brand	Audiovox
Model	Pursuit PRO-9744
Category	Car Alarm
Language	English

Summary

Transmitter Functions and Operation

Transmitter Icons (Symbols)

Details the icons and their functions on the 4-button transmitter pad.

Anti-Code Grabbing Transmitter

Explains the secure radio frequency transmission and its anti-theft features.

Remote Panic Operation

Describes how to activate the panic feature using the transmitter.

Standard Transmitter Options

Details options like remote trunk release and the function button.

System Arming and Disarming

Arming the System

Covers active, silent, and passive arming modes with LED and siren indications.

Protection While the System is Armed

Explains how the system protects against intrusion and vehicle starting.

Disarming the System

Details normal and silent disarming procedures and intrusion alerts.

System Management and Features

Valet Operation

Instructions for temporarily bypassing alarm functions using the valet switch.

Manual Override Operation

Procedure to override the system if the transmitter is lost or fails.

Intrusion Warning Signals

Interpreting LED flash patterns to identify the cause of alarm triggers.

Eliminating Arm/Disarm Chirps

How to disable or enable the audible arming and disarming confirmation chirps.

Remote Shock Sensor Control

Managing the shock sensor sensitivity and bypass for specific conditions.

System Functions at a Glance

Summary table of LED and siren/horn indications for system states.