128-8859
2 of 4
Battery Replacement
After removing the two #0 point
phillips screws shown, pry apart
case with the edge of a finger nail
or a small common screwdriver.
Keep hold of the metal key ring
loop to prevent its loss as it will
separate from the transmitter
case.
Carefully remove the
discharged batteries by sliding
them out from under the clip in the
direction indicated by the arrow
in the diagram. Properly dispose
of the exhausted batteries and
insert two new CR2032 batteries,
taking care to arrange them so
that the + is facing up toward the
+ symbol on the battery clip.
Reassemble in the reverse of
above.
This device complies with FCC Rules Part 15 Operation and
is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment.
2
To Next Page
Loading...
