9
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to choose “Backlight”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to set “Time out” (time
that the display will lower brightness in 10, 20, 30, 45, 60, 90, 120, 180 seconds or OFF).
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to set “On level”
(brightness of the Display when it is on).
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to set “Dim level”
[brightness of the Display when it is in Stand-by.
Select a language
• Press [Menu] on the unit or remote control.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings” on the submenu.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to choose “Language”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select the desired
language.
Factory reset
Note: Initiating a factory reset removes all presets, stored stations, alarms and resets all other options to default settings.
• Press [Menu] on the unit or on the remote control.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings” on the submenu
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “Factory reset”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “Yes”. The
device will be reset to factory settings. Select “No” if you do not want to reset to factory settings.
Software version
• Press [menu] on the unit or on the remote control.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings”.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control to select “System
Settings” on the submenu.
• Rotate and press [Enter/Next/Prev] on the unit or press [◄] or [►] and [OK] on the remote control on the remote control to
select “Software Version”.
• Press [Enter/Next/Prev] on the unit or press [OK] on the remote control to show the current version.
To Next Page
Loading...
