English
5.8 Line-In Mode
Use the provided audio cable to connect your source
device to the WR320.
Once the audio cable is plugged in, the receiver will
enter line-in mode automatically and the status LED
will light red.
In Line in mode, you will be able to play music from your
source device on some or all of the Wi-Fi receivers in
your multiroom system.
-18-
-17-
Problems Solutions
Unable to switch on • Check the power cable
• Ensure the USB port has power
6. Troubleshooting
Unable to connect
to the receiver via
Wi-Fi
• Ensure the Wi-Fi environment is 2.4 GHz
• Ensure the receiver is in Wi-Fi mode
• Ensure that both your device and the
are in the same network.
• To add a new speaker, please refer to
section 5.1.
• Press and Hold Reset on the speaker to
reset to factory setting, then try again.
receiver
Unable to pair my
Bluetooth source
device
• Confirm that the is in pairing mode.
• Confirm that the receiver is within 10m of
the source device
• Delete existing connection to speaker from
source device and pair again.
• Press and hold the multi-function button
for 2 seconds
receiver
Can't install the
Bluetooth driver
for the receiver
on a computer
• For Windows 7 and 8, update the
Bluetooth driver from the Bluetooth
module manufacturer's website. For further
information on you PC's Bluetooth module,
please consult your PC supplier.
• Bluetooth receivers are not supported by
Windows XP or Vista. A third party
Bluetooth driver can be used to solve
this issue.
There is no sound
from my Bluetooth
audio device
• Make sure the Bluetooth audio device is
connected to the speaker via Bluetooth.
• Check the volume on both source device
and your audio device.
No sound or
intermittent sound
in Wi-Fi mode.
• Ensure the Wi-Fi strength is good
• Reduce the audio quality in the app
• Reduce the usage of the router
To Next Page
Loading...
