AUMA AMB 01.1 - Page 3

216. Operation................................................................................................................................
216.1. Manual operation
216.1.1. Manual operation: engage
216.1.2. Manual operation: disengage
216.2. Motor operation
216.2.1. Local operation
226.2.2. Actuator operation from remote
237. Indications..............................................................................................................................
237.1. Indication lights
237.2. Mechanical position indicator/running indication
248. Signals.....................................................................................................................................
248.1. Feedback signals (binary)
248.2. Feedback signals (analogue)
259. Commissioning (basic settings)...........................................................................................
259.1. End stops in part-turn actuator
269.1.1. End stop CLOSED: set
269.1.2. End stop OPEN: set
279.2. Switch compartment: open
279.3. Torque switching: set
289.4. Limit switching: set
299.4.1. End position CLOSED (black section): set
299.4.2. End position OPEN (white section): set
299.5. Intermediate positions: set
309.5.1. Running direction CLOSE (black section): set
309.5.2. Running direction OPEN (white section): set
319.6. Test run
319.6.1. Direction of rotation: check
319.6.2. Limit switching: check
329.7. Electronic position transmitter EWG 01.1
339.7.1. Measuring range: set
349.7.2. Current values: adjust
349.7.3. LED end position signalling: switch on/off
349.8. Potentiometer
359.8.1. Potentiometer setting
359.9. Electronic position transmitter RWG
369.9.1. Measuring range: set
369.10. Mechanical position indicator: set
379.11. Switch compartment: close
3810. Commissioning – controls settings.....................................................................................
3810.1. Local controls: remove
3810.2. Type of seating: set
3910.3. Push-to-run operation or self-retaining: set
3910.3.1. Push-to-run operation or self-retaining for operation commands via push buttons
3910.3.2. Push-to-run operation or self-retaining for operation commands from Remote
4010.4. Local controls: mount
4110.5. Controls: open
4110.6. Feedback signals setting via output contacts
4210.7. EMERGENCY command (EMERGENCY - OPEN/EMERGENCY - CLOSE): set
4310.8. Controls: close
3
SQ 05.2 – SQ 14.2/SQR 05.2 – SQR 14.2
AMB 01.1 Table of contents