What to do if LED [DBG] on Profibus DP board of AUMA Control Unit is not illuminated?
If the LED [DBG] on the Profibus DP board of your AUMA Control Unit is not illuminated, ensure that the power supply to the AUMATIC is active by checking the fuses. Additionally, inspect the Profibus DP board itself for any issues.
Why is LED [DBG] on Profibus DP board of AUMA Control Unit blinking in green?
If the LED [DBG] on the Profibus DP board of your AUMA Control Unit is blinking green, it indicates that the 5 V power supply is not available. Ensure that the 5 V power supply is functioning correctly.
General| Brand | AUMA |
|---|---|
| Model | AUMATIC AC 01.2 |
| Category | Controller |
| Language | English |
Essential safety guidelines and standards.
Details the structure of the parameter telegram and how to set parameters.
Explains how to assign unique bus addresses to participants in a Profibus network.
Describes how to configure input/output byte allocation and data processing methods.
Describes how the master reads actuator states via input signals.
Details the default structure and meaning of input data bytes for actuator status.
Explains how the master controls the slave via output data.
Provides a troubleshooting table to diagnose and resolve Profibus DP communication issues.
To Next Page
