Need help?Do you have a question about the AUMA ACV 01.2 and is the answer not in the manual?
General| Input Voltage | 24 V DC |
|---|---|
| Output Voltage | 24 V DC |
| Communication Interface | Modbus RTU |
| Category | Controller |
| Operating Temperature | -20 °C ... +60 °C |
| Housing Material | Aluminum |
Ensures compliance with legal requirements, directives, guidelines, and national regulations for assembly, electrical connection, commissioning, and operation.
Explains safety-relevant procedures marked by signal words (DANGER, WARNING, CAUTION, NOTICE) and the safety alert symbol.
Describes how to operate the actuator using push buttons on the local controls, including OPEN, STOP, and CLOSE commands.
Describes operation when the selector switch is in the 'Local control' position.
Explains operation when the selector switch is in the 'Remote control' position via fieldbus or parallel interface.
Details the actuator's behavior during an emergency, initiated by an EMERGENCY signal.
Covers setting the type of seating (limit or torque) for the OPEN and CLOSED end positions.
Explains torque switching for overload protection and tripping in end positions.
Describes limit switching for tripping in end positions and signalling end positions.
Details setting speed for local and remote operation via various sources.
Explains the use and activation of a process controller for regulating pressure, flow, or temperature.
Defines the actuator's reaction to loss of signal or defective signals.
Describes the actuator's response to an EMERGENCY signal.
Explains how to interpret fault (red backlight) and warning (white backlight) indications on the display.
To Next Page
