AUMA ACV 01.2 User Manual

15. Asset Management
The Asset Management function provides information (operational data, signals,
reports and characteristics), which can be used within an asset management system
but also generally for support during commissioning, maintenance or corrective
action.
15.1. Operating data
Operating data provides details e.g. about the running time, the number of starts,
number of torque faults etc.
The analysis of this data provides valuable information regarding the optimization of
both actuator and valve.When using this information purposefully, actuator and valve
will be carefully operated, e.g. through appropriate parameter setting. In case of
faults, the logging of operating data allows for quick fault diagnostic.
View the operating data
Two counters are available, a lifetime counter and a resettable counter.
Asset Management M1231
Operational info M0177
Operational info total M0183
Operational info M0188
Description of the indications:
Operational info total = Lifetime counter
Operational info = Counter can be reset to 0
Table 21: Operating data
DescriptionIndication on display
Motor running time
Motor running time
Number of motor starts (starts)
Motor starts
Number of thermal faults (motor protection)
No. thermal faults
Number of torque faults in direction CLOSE
Torque fault CLOSE
Number of torque faults in direction OPEN
Torque fault OPEN
Number of limit switch trippings in direction CLOSE
Limit trip CLOSED
Number of limit switch trippings in direction OPEN
Limit trip OPEN
Number of torque switch trippings in direction CLOSE
Torque trip CLOSE
Number of torque switch trippings in direction OPEN
Torque trip OPEN
Total of all time intervals during which a start/run warn-
ing was signalled.
On time warning 1
Max. time interval during which a start/run warning was
signalled.
On time warning 2
Total of AUMATIC system starts
No. system starts
Maximum temperature of the controls
Max. temp. controls
Minimum temperature of the controls
Min. temp. controls
Maximum temperature of the MWG
Max. temp. MWG
Minimum temperature of the MWG
Min. temp. MWG
Operating hours counter: Number of hours during which
controls are supplied with power
Operating hours
Reset operating data
Required user level: Specialist (4) or higher.
Asset Management M1231
Operational info M0177
Reset operation. info M0197
The entries in the operating data logging can be reset (deleted) via this menu.
134
Actuator controls
Asset Management ACV 01.2/ACVExC 01.2 Profibus DP

AUMA ACV 01.2 Specifications

General

Brand	AUMA
Model	ACV 01.2
Category	Controller
Language	English