What to do if LED [DBG] on Profibus DP board of AUMA Control Unit is not illuminated?
If the LED [DBG] on the Profibus DP board of your AUMA Control Unit is not illuminated, ensure that the power supply to the AUMATIC is active by checking the fuses. Additionally, inspect the Profibus DP board itself for any issues.
Why is LED [DBG] on Profibus DP board of AUMA Control Unit blinking in green?
If the LED [DBG] on the Profibus DP board of your AUMA Control Unit is blinking green, it indicates that the 5 V power supply is not available. Ensure that the 5 V power supply is functioning correctly.
General| Brand | AUMA |
|---|---|
| Model | AUMATIC ACExC 01.2 |
| Category | Controller |
| Language | English |
Explains the use of warning signals and notes within the document.
Details the parameter setting within the Profibus standard and user-defined parameters.
Explains how to assign bus addresses (slave addresses) to participants on the Profibus network.
Describes selecting input/output bytes and data processing methods during configuration.
Covers updating process representation input using user parameters and available GSD files.
Lists and describes settable signals for the process representation input.
Covers monitoring the Profibus DP communication connection and fail-safe telegrams.
Covers redundant operation modes for increased installation security.
Explains time synchronization for accurate event recording and time stamping.
Provides a troubleshooting table for common Profibus DP communication problems and their causes/remedies.
Details how to check Profibus DP interface states using the Diagnostic M0022 menu.
Covers settings, programming, commands, signals, and general interface data for Profibus DP.
Details parameters, View Objects, data types, access, default values, and setting ranges.
To Next Page