AUMA AUMATIC AC 01.2 User Manual

Read operation instructions first.
●
Observe safety instructions.
Purpose of the document:
This document contains information for the commissioning staff of the distributed control system and DCS software
engineers.This document is intended to support the actuator integration into the DCS via fieldbus interface.
Reference documents:
●
Operation instructions (Assembly, operation, commissioning) for actuator
●
Manual (Operation and setting) AUMATIC AC 01.2 Profibus DP
Reference documents can be downloaded from the Internet (www.auma.com) or ordered directly from AUMA
(refer to <Addresses>).
Table of contents Page
41. Safety instructions.................................................................................................................
41.1. Basic information on safety
41.2. Range of application
51.3. Warnings and notes
51.4. References and symbols
62. General information about Profibus DP...............................................................................
62.1. Basic characteristics
62.2. Basic functions of Profibus DP
62.3. Transfer mode
62.4. Bus access
62.5. Functionality
72.6. Protective functions
72.7. Device types
83. Commissioning......................................................................................................................
83.1. Introduction
93.2. Parameter setting
103.3. Bus address (slave address)
103.4. Configuring the Profibus DP interface
113.5. Communication start-up
113.6. AUMA user parameters (AUMA specific parameters)
113.6.1. Process representation input arrangement (user parameters)
123.6.2. Settable (user definable) signals
173.6.3. Additional (user-definable) parameters (option)
173.6.4. Further adaptation options
183.7. Communication monitoring
183.7.1. Connection monitoring of the Profibus DP communication
183.7.2. Fail Safe and Global Control Clear telegrams
183.8. I & M functions
204. Description of the data interface .........................................................................................
204.1. Input data (process representation input) – signals
204.1.1. Process representation input (default process representation)
224.1.2. Description of the bytes in the process representation input
344.2. Output data (process representation output)
344.2.1. Process representation output arrangement
2
Actuator controls
Table of contents AC 01.2/ACExC 01.2 Profibus DP

AUMA AUMATIC AC 01.2 Specifications

General

Brand	AUMA
Model	AUMATIC AC 01.2
Category	Controller
Language	English