AUMA FQM 05.1 Operation Instructions

649.7.2. Limit switching: check
649.7.3. Reference operation position feedback: perform
649.8. Mechanical position indicator: set
659.9. Switch compartment: close
6610. Commissioning (optional equipment settings)...................................................................
6610.1. EWG 01.1 electronic position transmitter
6710.1.1. Measuring range: set
6710.1.2. Current values : adjust
6810.1.3. LED end position signalling: switch on/off
6810.2. Potentiometer
6810.2.1. Potentiometer: set
6910.3. RWG electronic position transmitter
6910.3.1. Measuring range: set
7111. Corrective action....................................................................................................................
7111.1. Faults during commissioning
7111.2. Fault indications and warning indications
7511.3. Fuses
7511.3.1. Fuses within the actuator controls
7611.3.2. Fuse replacement
7611.3.2.1. Replace fuses F1/F2
7711.3.2.2. Test/replace fuses F3/F4
7711.3.3. Motor protection (thermal monitoring)
7912. Servicing and maintenance...................................................................................................
7912.1. Preventive measures for servicing and safe operation
7912.2. Disconnection from the mains
7912.2.1. Disconnection from the mains with KP/KPH and KES electrical connection
8112.2.2. Disconnection from the mains with KT/KM electrical connection
8212.3. Maintenance
8212.4. Disposal and recycling
8413. Technical data.........................................................................................................................
8413.1. Technical data Part-turn actuator
8713.2. Technical data Actuator controls
9214. Spare parts.............................................................................................................................
9214.1. Part-turn actuators SQEx 05.2 – SQEx 14.2/SQREx 05.2 – SQREx 14.2 KT/KM
9414.2. Actuator controls ACExC 01.2 KP/KPH
9614.3. Actuator controls AUMATIC ACExC 01.2 KES
9814.4. Actuator controls ACExC 01.2 KT/KM
10015. Certificates..............................................................................................................................
10015.1. Declaration of Incorporation and EU Declaration of Conformity
103Index........................................................................................................................................
106Addresses...............................................................................................................................
4
SQEx 05.2 – SQEx 14.2 / SQREx 05.2 – SQREx 14.2 Control unit - electromechanical
Table of contents ACExC 01.2 Intrusive

AUMA FQM 05.1 Specifications

General

Brand	AUMA
Model	FQM 05.1
Category	Controller
Language	English