Need help?Do you have a question about the AUMA SG 05.1 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SG 05.1 |
| Category | Controller |
| Language | English |
General safety rules, standards, personnel qualifications, commissioning, and operation guidelines.
Defines intended use for industrial valves and lists prohibited applications.
Requirements for dust hazardous locations (Zone 22) and ATEX directive compliance.
Explains signal words (DANGER, WARNING, CAUTION, NOTICE) and their risk levels.
General warnings and information regarding electrical connections and protection.
Instructions for connecting using the AUMA plug/socket connector.
How to operate the actuator manually for setting and commissioning.
How to operate the actuator using the local control push buttons.
How to operate the actuator remotely via fieldbus.
Explains how status indications in the display show operation states, faults, and warnings.
Step-by-step instructions for setting the CLOSED end stop.
Step-by-step instructions for setting the OPEN end stop.
How to check and edit seating modes (LIMIT, OPEN, CLOSED) for end positions.
How to check and set torque switching for overload protection.
Steps to set limit switching for OPEN and CLOSED end positions.
How to set Modbus interface parameters like baud rate, parity, and slave address.
How to check the direction of rotation and precautions to avoid valve damage.
How to check if the limit switching is set correctly.
Common faults during commissioning and their remedies.
Explains fault and warning indications shown in the display.
Details how S0 displays faults and warnings and lists signal descriptions.
Describes fault indications within status indication S1 and their remedies.
Explains motor protection via PTC thermistors/thermoswitches and associated signals.
Lists key features and functions of the part-turn actuators.
Lists key features and functions of the AUMATIC actuator controls.
Details settings, commands, signals, and general data for the Modbus interface.
To Next Page
