To Next PageTo Next Page
Need help?Do you have a question about the AUMA SG 05.1-F07 and is the answer not in the manual?
General| Mounting flange | F07 |
|---|---|
| Protection class | IP 67 |
| Control | Modulating |
| Voltage | 24 V DC |
| Communication | Modbus RTU, PROFIBUS DP |
General safety information, standards, user responsibilities, and staff qualification.
Explains safety symbols (DANGER, WARNING, CAUTION, NOTICE) and their risk levels.
Detailed instructions and dimensions for fitting the coupling.
General safety warning for electrical connections and information on wiring diagrams.
Details on connecting the actuator using the AUMA plug/socket connector.
Detailed instructions for connecting cables, including protective earth connection.
How to connect bus cables to the connection board, including versions and safety warnings.
How to engage and disengage manual operation for setting and commissioning.
General instruction to perform commissioning and test run before motor operation.
How to operate the actuator using the local control push buttons.
How to switch the selector to REMOTE for fieldbus control.
Explains how to use push buttons to navigate menus, view, and edit settings.
Steps to enter the password for protected parameters.
Guide to setting Modbus interface parameters like baud rate, parity, and slave address.
Table of common faults during commissioning, their causes, and remedies.
Explains fault and warning indications shown on the display.
Technical specifications for the Modbus interface, including communication protocol.
