AUMA SG 05.1-F07 User Manual

6. Operation
6.1 Manual operation
In case of motor failure or power failure, the actuator may be operated manually for
purposes of setting and commissioning.
The handwheel does not rotate during motor operation. Change-over from motor
operation to manual operation is not required.
6.1.1 Manual operation: engage
→
Engage manual operation by pulling the handwheel.
Information Turning the handwheel during motor operation extends or reduces the operating time,
depending on the direction of rotation.
6.1.2 Manual operation: disengage
→
Release handwheel.
➥
A spring pulls back the handwheel into the initial position.
Information Handwheel must engage, assist by turning manually, if required
6.2 Motor operation
✔
Perform all commissioning settings and the test run prior to motor operation.
6.2.1 Local operation
The local operation of the actuator is performed using the push buttons of the local
controls.
27
SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1 Control unit: electromechanic
AC 01.1 Intrusive Modbus RTU Operation

AUMA SG 05.1-F07 Specifications

General

Brand	AUMA
Model	SG 05.1-F07
Category	Controller
Language	English