AUMA SG 05.1-F07 User Manual

11. Servicing and maintenance
Damage caused by inappropriate maintenance!
→
Servicing and maintenance must be carried out exclusively by suitably qualified
personnel having been authorised by the end user or the contractor of the plant.
→
Only perform servicing and maintenance tasks when the device is switched off.
Service
AUMA offers extensive service such as servicing and maintenance as well as
customer product training. For the relevant contact addresses, please refer to
<Addresses> in this document or to the Internet (www.auma.com).
11.1 Preventive measures for servicing and safe operation
The following measures are required to ensure safe device operation:
Every 6 months after commissioning and then every year
●
Carry out visual inspection:
Cable entries, cable glands, blanking plugs, etc. have to be checked for correct
tightness and sealing.
Consider torques according to manufacturer's details.
●
Check fastening screws between actuator and gearbox/valve for tightness. If
required, fasten screws while applying the fastening torques as indicated in
chapter <Assembly>.
●
When rarely operated: Perform test run.
For enclosure protection IP 68
After submersion:
●
Check actuator.
●
In case of ingress of water, locate leaks and repair, dry device correctly and
check for proper function.
11.2 Maintenance
Lubrication
●
In the factory, the gear housing is filled with grease.
●
Change of grease or re-lubrication will be required in case of lubrication loss
only.
11.3 Disposal and recycling
AUMA devices have a long lifetime. However, they have to be replaced at one point
in time.The devices have a modular design and may, therefore, easily be separated
and sorted according to materials used, i.e.:
●
electronic scrap
●
various metals
●
plastics
●
greases and oils
The following generally applies:
●
Greases and oils are hazardous to water and must not be released into the
environment.
●
Arrange for controlled waste disposal of the disassembled material or for sepa-
rate recycling according to materials.
●
Observe the national regulations for waste disposal.
62
SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1 Control unit: electromechanic
Servicing and maintenance AC 01.1 Intrusive Modbus RTU

AUMA SG 05.1-F07 Specifications

General

Brand	AUMA
Model	SG 05.1-F07
Category	Controller
Language	English