Need help?Do you have a question about the AUMA SAR 6 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SAR 6 |
| Category | Controller |
| Language | English |
Standard multi-turn actuator with torque range 3 m kg to 100 m kg and output speed 4 rpm to 180 rpm.
Compact version of integral starter multi-turn actuator with local/remote control.
Electronic version of integral starter multi-turn actuator with field programming.
Actuator designed for hazardous or explosive areas, complying with flame proof standards.
Actuator operates to end positions in an open-loop system with infrequent operation.
Actuator operates in a closed-loop system, adjusting valve position based on input signals.
Convert mechanical parameters (travel, torque) into electrical signals for actuator control.
Includes mechanical indicators with discs and remote indicators via potentiometers.
Details 3-phase, single-phase AC, and DC motors used in actuators, including technical data.
Thermo switches protect motor windings from overheating by interrupting the control circuit.
Details SAR actuators for regulating duty, highlighting differences from SA actuators and selection points.
Diagram and explanation of the closed-loop operation for regulating duty actuators.
Details electronic units like potentiometers and transducers used for position feedback.
Three-level positioner comparing input signals to control actuator operation via relays.
Standard actuator with electric motor, torque switch, limit switches, and blinker switch.
Actuators with integral controls to save installation costs, ready for use.
Simpler Integral Starter Unit with selector switch and push buttons for local/remote control.
Electronic version with field programming, modular construction (Power, Relay, Control Modules).
Specifies valve attachment according to ISO 5210 or DIN 3210, including flange sizes and torque ratings.
Details various output drive types (Stem nut, Plug Sleeve, Dog Coupling, Stub Shaft, Bore with Keyway) according to ISO 5210/DIN 3210.
Details screw-type terminals and plug socket connectors for actuator wiring.
Details combinations with Worm, Bevel, and Lever Gear boxes to extend torque/speed ranges.
Details IP67 and IP68 enclosure protection standards for dust and water resistance.
Specifies operating temperature ranges for different actuator types (SA, SAR, SAEX/SAREx/SACEx/SARCEx).
Specifies protective measures for hazardous areas according to IS 2148-1981, tested and certified.
To Next Page
