AUMA SAR 07.1 - SAR 30.1 User Manual

Certificate Registration No.
12 1
00/
1
0
442
69
Electric multi-turn actuators
Operation instructions
SA 07.1 – SA 30.1
SAR 07.1 – SAR 30.1
with actuator controls
AUMA MATIC AM 01.1/AM 02.1

AUMA SAR 07.1 - SAR 30.1 Specifications

General

Brand	AUMA
Model	SAR 07.1 - SAR 30.1
Category	Controller
Language	English

Summary

Safety Instructions

Warnings and Notes Importance

Highlights the critical nature of warnings and notes for preventing injury and damage.

Technical Data

Mounting to Valve/Gearbox

Electrical Connection

Connection with AUMA Plug/Socket Connector

Manual Operation

Local Controls Operation and Indications

Selector Switch Functions

Describes the functions of the selector switch positions (OFF, Local, Remote, Test, Reset).

Push Button Operations

Details the operation of OPEN, STOP, CLOSE push buttons and their modes.

Opening the Switch Compartment

Setting the Limit Switching

Setting End Position CLOSED

Procedure for setting the CLOSED end position using the control unit spindle.

Setting End Position OPEN

Procedure for setting the OPEN end position using the control unit spindle.

Checking Limit Switches

How to manually test the function of the limit switches using test buttons.

Setting the DUO Limit Switching (Option)

Setting Direction CLOSE

Setting the intermediate position for closing direction using setting spindle G.

Setting Direction OPEN

Setting the intermediate position for opening direction using setting spindle K.

Checking DUO Limit Switches

Setting the Torque Switching

Torque Switching Setting

Procedure for setting the torque limit values for OPEN and CLOSE directions.

Checking Torque Switches

Test Run Procedures

Checking Direction of Rotation

Checking Limit Switching Settings

Checking PTC Tripping Device (Option)

Setting the Potentiometer (Option)

Setting Electronic Position Transmitter RWG (Option)

Setting 2-wire / 3-4 wire Systems

Setting 3-/4-wire System 4–20 mA

Setting the Mechanical Position Indicator (Option)

Closing the Switch Compartment

Actuator Controls AUMA MATIC

Programming the Logic Board

EMERGENCY OPEN/CLOSE Signal (Option)

Electronic Positioner (Option)

Positioner Setting

Positioner Adjustment for End Position CLOSED (Standard)

Step-by-step adjustment procedure for the CLOSED end position.

Positioner Adjustment for End Position OPEN (Standard)

Step-by-step adjustment procedure for the OPEN end position.

Setting the Sensitivity

Positioner Adjustment OPEN (Inverse Operation)

Setting the OPEN end position for inverse operation using specific switch settings.

Positioner Adjustment CLOSED (Inverse Operation)

Setting the CLOSED end position for inverse operation using specific switch settings.

Positioner in Split Range Version (Option)

Timer (Option)

Setting Stepping Mode Start/End via DUO Limit Switch

Setting ON and OFF Times

Fuses

Motor Protection

Maintenance and Service