Need help?Do you have a question about the AUMA SAR 14.5 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SAR 14.5 |
| Category | Controller |
| Language | English |
General safety principles, standards compliance, and user responsibilities for AUMA products.
Explains warning symbols (DANGER, WARNING, CAUTION, NOTICE) and their meanings.
Details mounting procedures for output drive types B, B1-B4, and E.
Instructions for mounting the actuator with output drive type A to the valve.
General safety warnings and essential information before making electrical connections.
Details on cross-sections and connections for the AUMA plug/socket system.
Instructions for connecting cables, including PE connection and safety warnings.
Details on connecting bus cables for standard and redundant versions.
How to operate the actuator manually for setting or in case of power failure.
Step-by-step guide to engage manual operation using the change-over lever.
How to operate the actuator using the local control push buttons.
How to use push buttons for navigating menus and changing settings.
Explains the meaning of status indications (S0/S6) in the display.
Details the various lines and information displayed for operation status.
How to check and edit limit and torque seating for end positions.
Guides on setting Modbus interface parameters like baud rate, parity, and slave address.
Procedure for setting the torque switching heads for CLOSE and OPEN directions.
Step-by-step guide to set the end position CLOSED using the setting spindle.
Step-by-step guide to set the end position OPEN using the setting spindle.
Procedure to check the actuator's direction of rotation and safety warnings.
How to verify if the limit switching is set correctly using indications.
Steps to perform reference operation for position feedback after setting limit switching.
Lists common faults during commissioning, their causes, and remedies.
Explains fault and warning indications shown in the display.
Details the fault and warning signals displayed in status indication S0.
Lists and describes faults indicated in status indication S1.
Lists and describes warnings indicated in status indication S2.
Explains motor protection via PTC thermistors/thermoswitches and associated signals.
Lists measures for safe operation and servicing, including visual inspection and lubrication.
Details the Modbus interface, commands, signals, and general data.
To Next Page
