Need help?Do you have a question about the AUMA SAR 10.1 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SAR 10.1 |
| Category | Controller |
| Language | English |
General safety principles, standards, directives, and user responsibilities.
Requirements for using actuators in dust hazardous locations (Zone 22).
Details about actuator and controls name plates and their information.
Details on mounting actuators with specific output drive types to valves/gearboxes.
Details for mounting actuators with output drive type A.
General safety information and prerequisites for electrical connection.
How to operate the actuator manually for settings or power failure.
Overview of motor operation modes.
How to operate the actuator using local control buttons.
How to check and set valve seating for end positions (limit/torque).
Steps to set Modbus interface parameters: baud rate, parity, slave address.
How to set the torque switching heads for OPEN and CLOSE directions.
Explains how limit switching records travel and operates switches.
Step-by-step guide to set the CLOSED end position for limit switching.
Step-by-step guide to set the OPEN end position for limit switching.
How to set intermediate positions for DUO limit switching.
Procedures for performing a test run after settings.
How to check the actuator's direction of rotation.
How to adjust the potentiometer for travel sensing.
Setting the electronic position transmitter (RWG) for valve position measurement.
Common faults encountered during commissioning and their remedies.
Explains fault and warning indications shown in status S0.
Details fault indications within status indication S1 and their remedies.
Details warning indications within status indication S2 and their remedies.
How motor protection operates and the signals it generates.
Measures for safe operation and servicing, including visual inspection and lubrication.
Settings and programming for the Modbus interface, including commands and signals.
To Next Page
