6.4 Password entry
In the menu (group M), the settings are password protected.To change the
parameters, a password must be entered first.The following default password is set
in the factory: 0000.
After selecting EDIT, the following is displayed:
ENTER PASSWORD
0 * * *
:EDIT :OK C:ESC
Step by step:
1.
Select figures 0 to 9: Press .
2.
Move to the next position: Press .
3. Repeat steps 1 and 2 for all four digits.
4. To cancel a process: Press C.
Information If no input is received over a longer period of time (approx. 10 min.), the controls
automatically return to status indication S0.
6.5 Language change in the display
Via the menu to parameter:
MAIN MENU (M0)
LANGUAGE/CONTRAS (M00)
VIEW (M00)
EDIT (M01)
LANGUAGE (M010)
Default value: ENGLISH
Setting range: ENGLISH, GERMAN, MAGYAR, POLSKI, TUERKCE,
PORTUGUESE, ITALIAN, SPANISH, FRENCH
Step by step:
1. Set selector switch to position 0 (OFF).
2. Press C and hold it down for approx. 3 seconds.
➥
Display indicates:
MAIN MENU M0
LANGUAGE/CONTRAST
SETTINGS
OPERATIONAL DATA
3.
Press .
➥
Display indicates:
LANGUAGE/CONTRAS M00
VIEW
EDIT
32
SA 07.1 – SA 16.1/SAR 07.1 – SAR 16.1 Control unit: electromechanic
Operation AC 01.1 Intrusive Modbus RTU
To Next Page
Loading...
