Need help?Do you have a question about the AUMA SGExC 07.1-F07 and is the answer not in the manual?
General| Type | SGExC 07.1-F07 |
|---|---|
| Torque range | 10 - 100 Nm |
| Mounting flange | F07 |
| Ambient temperature | -20 °C to +60 °C |
| Communication Protocol | Modbus |
| Protection Class | IP67 |
| Explosion protection | ATEX |
| Actuator signal | 4-20 mA |
| Type of Protection | Flameproof enclosure 'd' |
Explains the meaning of warning symbols (DANGER, WARNING, CAUTION, NOTICE).
Describes the name plates on the actuator and controls for identification.
Guidance on how to mount the part-turn actuator to the valve.
Details the coupling process for connecting the actuator to the valve shaft.
Covers essential safety warnings, wiring diagrams, and network requirements.
Details the connection process using KP/KPH plug/socket connectors.
Details the connection process using KES plug/socket connectors.
Instructions for opening the terminal compartment for KES connectors.
Details cable connection procedures for KES terminal blocks.
Provides terminal assignments for connecting bus cables in line and loop topologies.
Steps to close the terminal compartment after electrical connections are made.
Explains how to engage and disengage manual operation using the handwheel.
Indicates active faults with a blinking exclamation mark.
Indicates actuator function failures or invalid output signals as per NAMUR.
Explains the function of internal end stops and how to set them.
Step-by-step guide to set the CLOSED end stop for the actuator.
Step-by-step guide to set the OPEN end stop for the actuator.
Guides on setting the valve seating type (Limit or Torque).
Explains how to set torque switching limits for valve overload protection.
Guides on setting the limit switches for end positions.
Step-by-step instructions for setting the CLOSED end position limit switch.
Step-by-step instructions for setting the OPEN end position limit switch.
Outlines the test run procedure after all settings are complete.
Lists common faults during commissioning and their remedies.
Explains fault and warning indications displayed on the device.
Lists and explains faults/warnings indicated on the display.
Details specific warnings and out-of-specification conditions.
Lists and explains faults and failure indications with remedies.
Explains indications for remote unreadiness and function check failures.
Explains the motor's thermal monitoring system and fault indications.
Lists features like explosion protection, type of duty, motor, and limit switching.
Details controls features like power supply, current consumption, and interfaces.
Specifies Modbus interface settings, commands, signals, and protocol details.
Official EC type-examination certificate for explosion protection.
To Next Page
