Need help?Do you have a question about the AUMA SA 07.5 and is the answer not in the manual?
General| Type of actuator | Multi-turn |
|---|---|
| Ambient temperature | -25°C to +70°C |
| Protection class | IP67 |
| Voltage | 3-phase AC, 1-phase AC, DC |
| Control | Modulating |
| Communication | PROFIBUS DP, Foundation Fieldbus |
General safety guidelines, standards, and personnel qualifications.
Instructions for mounting actuators to valves/gearboxes, covering different output drive types.
General safety warnings and guidelines for electrical connections.
Connecting the actuator using the AUMA plug/socket connector, including terminal compartments and cable connections.
Instructions for opening, closing, and connecting bus terminal compartments and bus cables.
How to operate the actuator manually for setting or in case of power failure.
How to operate the actuator using local control push buttons.
Using push buttons to navigate menus for settings and view indications.
Setting baud rate, parity, slave address, and other Modbus parameters.
Lists common faults encountered during commissioning and their remedies.
Explains fault and warning indications shown in status S0.
Details the fault indications displayed in status S1.
Explains warning indications displayed in status S2.
Explains causes for the 'not ready remote' status.
Information about the location and types of fuses within the actuator controls.
Explains how motor protection works and the related signals.
Details on Modbus interface settings, commands, signals, and data.
To Next Page
