Need help?Do you have a question about the AUMA SA 14.5 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SA 14.5 |
| Category | Controller |
| Language | English |
General safety principles, standards, directives, and user responsibilities for safe operation.
Requirements for using actuators in dust hazardous locations (Zone 22) per ATEX directive.
Details mounting procedures for actuators to valves or gearboxes.
Describes mounting procedures specific to output drive types B, B1-B4, and E.
Covers Type A output drive mounting and stem nut machining.
General safety precautions and information before making electrical connections.
Details on connecting via the AUMA plug/socket connector.
Instructions for connecting cables, including protective earth.
Instructions for connecting bus cables to the connection board.
How to operate the actuator manually for setting and commissioning.
Operating the actuator via motor and local control buttons.
Instructions for operating the actuator remotely via fieldbus.
Using push buttons for navigating menus, settings, and indications.
Explanation of status indications shown on the actuator display.
Procedures for checking and editing valve seating settings.
Setting Baud rate, parity, and Modbus address.
Procedure for setting the torque switching limits.
How limit switching records travel and operates switches.
Performing test runs and checking the direction of rotation.
Common faults during commissioning and their solutions.
Setting and programming the Modbus interface parameters.
To Next Page
