Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
TypeDesignationRef. no.TypeDesignationRef. no.
Sub-assemblyPotentiometer without slip clutch556.1Sub-assemblyDrive shaft005.0
Sub-assemblyHeater557.0Sub-assemblyMotor coupling005.1
Sub-assemblyBlinker transmitter including pins at wires
(without impulse disc and insulation plate)
558.0Sub-assemblyManual drive coupling005.3
Sub-assemblyElectromechanical control unit with
switches, including torque switching heads
559.0–1Worm wheel006.0
Sub-assemblyElectronic control unit with magnetic limit
and torque transmitter (MWG)
559.0–2Sub-assemblyManual gearing009.0
Sub-assemblySwitch stack for direction OPEN560.0–1Sub-assemblyTorque lever017.0
Sub-assemblySwitch stack for direction CLOSE560.0–2Gear segment018.0
Sub-assemblySwitch for limit/torque560.1Sub-assemblyCrown wheel019.0
Switch case for direction OPEN560.2–1Drive pinion II for torque switching022.0
Switch case for direction CLOSE560.2–2Sub-assemblyOutput drive wheel for limit switching023.0
Sub-assemblyRWG position transmitter566.0Sub-assemblyDrive wheel for limit switching024.0
Sub-assemblyPotentiometer for RWG without slip clutch566.1Sub-assemblyLocking plate025.0
Sub-assemblyPosition transmitter board for RWG566.2Sub-assemblyCable for protective earth058.0
SetCable set for RWG566.3Sub-assemblyMotor (incl. ref. no. 079.0)070.0
Sub-assemblySlip clutch for potentiometer567.1Sub-assemblyPlanetary gearing for motor drive079.0
Sub-assemblyMotor coupling on motor shaft583.0Sub-assemblyReduction gearing155.0
Pin for motor coupling583.1Sub-assemblyCover500.0
Sub-assemblyRetaining spring for motor coupling584.0Sub-assemblyPin carrier without pins502.0
Sub-assemblyOutput drive flange with end stop596.0Sub-assemblyPin for controls505.0
Sub-assemblyScrew plug for end stop612.0Sub-assemblyPin for motor506.0
Sub-assemblyEWG position transmitter614.0Sub-assemblyCoupling525.0
MWG 05.3 cover627.0Sub-assemblyScrew plug539.0
Ex plug/socket connector with terminal
connection (KT)
628.0Sub-assemblyProtective earthing541.0
Sub-assemblyPinion shaft629.0Sub-assemblyHandwheel with ball handle542.0
SetSeal kit, smallS1Sub-assemblyMechanical position indicator553.0
SetSeal kit, largeS2Socket carrier for motor plug/socket con-
nector with cable harness
554.0
Sub-assemblyPotentiometer for position transmitter556.0
100
SQEx 05.2 – SQEx 14.2/SQREx 05.2 – SQREx 14.2 Control unit: electronic (MWG)
Spare parts ACExC 01.2 Non-Intrusive Profibus DP