AUMA SQ 07.2 Manual

307.2. Motor operation
307.2.1. Operating the actuator from local controls
317.2.2. Actuator operation from remote
327.3. Menu navigation via push buttons (for settings and indications)
337.3.1. Menu layout and navigation
347.4. User level, password
347.4.1. Password entry
357.4.2. Password change
357.4.3. Timeout for incorrect password entry
367.5. Language in the display
367.5.1. Language change
378. Indications..............................................................................................................................
378.1. Indications during commissioning
378.2. Indications in the display
388.2.1. Feedback signals from actuator and valve
408.2.2. Status indications according to AUMA classification
418.2.3. Status indications according to NAMUR recommendation
438.3. Indication lights of local controls
438.4. Mechanical position indication (self-adjusting)
448.5. Mechanical position indication via indicator mark (not self-adjusting)
459. Signals (output signals).........................................................................................................
459.1. Status signals via output contacts (digital outputs)
459.1.1. Assignment of outputs
459.1.2. Coding the outputs
459.2. Analogue signals (analogue outputs)
4610. Commissioning (basic settings)...........................................................................................
4610.1. End stops in part-turn actuator
4710.1.1. Set end stop CLOSED
4710.1.2. Set end stop OPEN
4810.2. Type of seating: set
4910.3. Torque switching: set
5110.4. Limit switching: set
5210.5. Test run
5310.5.1. Direction of rotation at mechanical position indicator: check
5310.5.2. Limit switching: check
5511. Commissioning (settings in the actuator)...........................................................................
5611.1. Switch compartment: open/close
5611.2. Mechanical position indicator (self-adjusting)
5611.2.1. Mechanical position indicator: set
5711.2.2. Gear stage of the reduction gearing: test/set
5811.3. Mechanical position indication via indicator mark (not self-adjusting)
5911.3.1. Mechanical position indicator: set
5911.3.2. Gear stage of the reduction gearing: test/set
6112. Corrective action....................................................................................................................
6112.1. Faults during commissioning
6112.2. Fault indications and warning indications
6512.3. Fuses
6512.3.1. Fuses within the actuator controls
3
SQ 05.2 – SQ 14.2/SQR 05.2 – SQR 14.2 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive Table of contents

AUMA SQ 07.2 Specifications

General

Brand	AUMA
Model	SQ 07.2
Category	Controller
Language	English