AUMA SQV 05.2 User Manual

578.3.2. Signal behaviour of intermediate positions: set
588.3.3. Hysteresis for intermediate positions: set
588.4. Operation profile (operation behaviour) for intermediate positions
598.4.1. Operation profile: activate
598.4.2. Operation profile for intermediate positions (pivot points): set
608.4.3. Off times for intermediate positions (pivot points): set
608.5. Two-wire control
608.6. Positioner (operation mode Remote SETPOINT)
618.6.1. Positioner: activate
618.6.2. Adaptive behaviour: activate deactivate
628.6.3. Overrun (inner dead band): set manually
628.6.4. Max. error variable (outer dead band): set manually
638.6.5. Dead time: set
638.6.6. Hysteresis for positioner: set
638.6.7. Closing fully/opening fully (end position tolerance for setpoint)
638.6.8. Setting range: limit
648.6.9. Speed reduction before reaching setpoint position
658.6.10. Change-over between OPEN - CLOSE control and setpoint control
668.6.11. Input of setpoint position
668.6.12. Input range of setpoint position
678.6.13. Split Range operation
678.7. Process controller
688.7.1. Process controller activation
698.7.2. Process controller: set modulating behaviour
708.7.3. Setpoint source (input for process setpoint)
708.7.4. Behaviour on loss of process setpoint
708.7.5. Inverse operation
708.7.6. Internal process setpoint
718.7.7. Setting procedure
718.7.8. Proportional gain Kp: set
718.7.9. Reset time Ti: set
718.7.10. Rate time Td: set
728.7.11. Actual value source (input for actual process value)
728.7.12. Speed source for actual process value
728.8. Stepping mode
738.8.1. Stepping mode: activate
738.8.2. Operation mode for stepping mode
748.8.3. Start and end of stepping mode
748.8.4. On times and off times
748.9. Profibus DP interface
748.9.1. Bus address (slave address)
758.9.2. Redundancy
758.9.3. Response telegrams for AUMA redundancy II
758.9.4. Connection type – compatibility with process representation
768.10. Additional inputs for fieldbus
768.11. Combination of fieldbus-parallel interface
778.12. Auto change-over I/O (during fieldbus failure)
788.13. Functions for FO cable connection
788.13.1. FO cable monitoring: activate/deactivate
788.13.2. FO cable topology: check setting
4
Actuator controls
Table of contents ACV 01.2/ACVExC 01.2 Profibus DP

AUMA SQV 05.2 Specifications

General

Brand	AUMA
Model	SQV 05.2
Category	Controller
Language	English