Aura Roboclean Splus 114K - Filling the Basin with Water; Connecting the Vacuum Hose

! WARNING
This hose includes electrical connections;
• It should not be used for sucking up water or other liquids.
• It should not be immersed in water for cleaning.
• Hose should be checked regularly and should not be used if
it is damaged.
FILLINGTHEBASINWITHWATER
CONNECTINGTHEVACUUMHOSETOTHEBODY
1 Release the latches on both sides of the appliance.
Separate the main body from the water basin.
2 Fill the dirty water basin with clean water up to the top of the measuring
postinitscenter.Thewateramounttobelledisabout1.8L.(Please
ensurethatthewaterdoesnotexceedtheheightofthemeasuringpost).
! Do not operate the appliance without water.
3Putthewater-lledbasin,intothecleanwaterbasinandplaceitonthe
dolly.
4 Securethebodytothedollywiththelockinglatches.
5Lifttheoutletcoveronthebodyupwardsasshowninthegure.
6 Press the hose adaptor on the end of the vacuum hose into latches on the
sides,andsecureitonthebodybypushingitsothattheplugsandlocks
engageeachother.Ensurethatthetabsarelockedbypullingthehose
slightly.
7 Toseparatethevacuumhosefromthebody,presstheclampsonbothsides
of the hose adaptor and pull the hose towards you.
1 2 6
5
15