Aura Roboclean Splus 114K - Setting up the Power Nozzle

3 PlugthePowerNozzlecordinto
thedualsocketslotunderthe
trigger arm.
2 Installtheothersideofthe
telescopic tube to the joint part
ofthePowerNozzlesothatthe
lockingpinisengaged.
4 Installthecordretainingclampstothe
telescopictubeequaldistancefromeach
othersothattheyholdthePowerNozzle
cord.Toadjustthelengthofthetelescopic
tube, push the button located at the center
of the tube in the direction of the arrow and
adjust the tube to the desired length.
5 Beforestartingtovacuum,press
the joint retaining latch on the
PowerNozzletoreleasethe
tube from upright position.
1Installthetelescopictubetothe
tube adaptor on the end of the
vacuumhosesothatthelocking
pin is engaged.
Setting up the Power
Nozzle
16