Aura Roboclean Splus 114K - Usage and Cord Management; Using the Power Nozzle

17
! WARNING
• Do not use the Power Nozzle to suck up water or liquids and do not use it on wet surfaces.
• Do not use the Power Nozzle on leather surfaces, carpets made from animal hide, fur or hair, shaggy
carpets, handmade rugs, Aloe Vera mattresses, and carpets made with soft bers.
• It is not recommended to use the Power Nozzle to clean mattresses. It is recommended to clean
mattresses with Roboclean Small Power Nozzle.
• Before using the Power Nozzle on any type of surface such as carpets, rugs, upholstery and mattresses;
read the user and owner care manuals of these products. The Power Nozzle may cause damage on
surfaces that are not suitable to be cleaned with the Power Nozzle.
• In case the Power Nozzle becomes obstructed by bristles, bers and/or other materials; do not attempt
to use it before removing any of these obstructions. Clean the cylinder and resume operation.
• Make sure to unplug your Roboclean before performing any sort of cleaning or maintenance on it.
• Do not let children use your Roboclean device as a toy or operate it without supervision.
1 Unplug power cord by pulling it out of its housing.
2Afteradjustingthetothedesiredlengthandhearingitclick,releaseit.Thisactionwilllockthe
cordandpreventitfromgettingpulledbackinitshousing.Theredlineonthecordindicatesthe
endofthecordlength.Donotpullthecordmorewhenyouseethissign.
3Afterallconnectionsareperformed,plugintheapplianceandbringittothestandbyposition.
4Ifyouwantthecordtobepulledbackintoitshousing,slightlypullandreleaseit.Holdthecord
inyourhandtoensurethatitispulledbackintoitshousinginacontrolledmanner.
5Neverletchildrenplaywiththecord.
USAGEANDREWINDINGOFTHEPOWERCORD
USAGEOFTHEPOWERNOZZLE
a. When you want to operate the appliance from the body control panel;
• Activatethesuctionmotorbytouchingthe[
]On/Offsymbol.
• ActivatethePowerNozzlebytouchingthe[
] symbol. Press the same button
when you want to stop it.
b. If you want to operate the appliance from the trigger control panel;
•StartthesuctionmotorbypressingtheOn/Offbutton.
•StartthePowerNozzlebytouchingthe[
] button. Press the same button when
you want to stop it.
WhenyouactivatethePowerNozzle,yourappliancewillbeginoperatingatthemaximum
level automatically.
Afteryouhavecompletedvacuuming,stoptheappliancebypressingtheOn/Offbuttononthe
remotecontrolortouchingthe[
]On/Offsymbolonthebodyandunplugtheappliance.
Securethetelescopictubebypushingitforwardtobringittotheuprightpositionwhenrequ-
ired.