Aussie MONARO 7652K1 - Step 3: Wheel Assembly

STEP 3-Wheel
Assembly
(ITEM 9) Wheel
(ITEM 8) Washer
(Axle)
(ITEM 10) Axle Nut
7
· Remove Axle Nuts from Axle. Insert Axle through both sides of Wheel Legs. Place Axle Washers
onto each end of Axle.
· Position Wheel hub recess to the outside and slide a Wheel onto each end of Axle.
· Attach Axle Nut onto each end of Axle. Tighten each side with wrench or pliers.
Wheel hub recess
this side
Axle Washer
Axle Nut
7 with Item 10 installed