Setting heat modes and time
1. After setting E2 value for SU (Sunday) by pressing enter now press the menu button.
2. PS (Power start) will appear in the display. Under PS will be displayed a number this is
for heat intensity. Press ‘plus’ or ‘minus’ to set heat intensity 0 being the lowest up to 100
(highest).
3. Press enter to confirm values.
4. The display will now show PE (Power end) with the word ‘off’ under PE. Off means the
fire is switched off between heating programs. If you want the stove to run at a low
setting between heating programs use the ‘plus’/’minus’ to set the heat output.
5. Press enter again and the values are saved.
6. The display now reads CL(cleaning cycle) and 60 under the CL. Once each hour the
stove will ramp up to the heat setting for 1 ½ minutes to clean out the burn pot. After
which it will return to its original setting. This can be changed by pressing the ‘plus’ or
‘minus’ button. We highly recommend leaving this at 60
7. Press enter and VA (software version). Under this will appear the software version
1.22,ie.
8. Press menu and H (hour) appears with a number below on the display. This a 24 hour
clock using the ‘plus’ ‘minus’ buttons sets hour.
9. Press enter and M (minute) appears using the ‘plus’ ‘minus button set minutes.
10.Press enter and D(day) appears in the display. Set the current day by pressing ‘plus’ or
‘minus’ (1=Monday, 2= Tuesday etc.) Press enter confirming the new values.
11.Press Menu and return to SB (stand-by)
STARTING PROCEDURE
22
To Next Page
Loading...
