EasyManua.ls Logo

Austroflamm Integra II - Safety Precautions; General Safety and Fuel Warnings; Electrical and Ash Handling Safety

Austroflamm Integra II
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
4
READ THESE SAFETY
PRECAUTIONS BEFORE
INSTALLING OR USING STOVE
The Austroflamm Integra II Insert
wood pellet stove must be properly
installed in order to prevent the
possibility of a house fire. For your
own safety, you must adhere strictly
to the installation instructions. Con-
tact your local building officials to
obtain a permit and information on
any installation restrictions and
inspection requirement in your area.
Failure to follow these instructions
could result in property damage,
bodily injury or even death.
The word “stove”, as used in this manual,
means the Austroflamm Integra II Insert
wood pellet stove
The stove’s exhaust system works with
negative combustion chamber pressure and
a slightly positive chimney pressure. It is
therefore imperative that the air intake
and exhaust system be air tight and
installed correctly.
BURN WOOD PELLET FUEL ONLY!
NEVER BURN ANY OTHER FUEL
SUCH AS PAPER, SOLID WOOD
OR CHARCOAL!
WARNING
When operated properly, the stove
cannot be over fired. However,
continuous operation at maximum burn
may shorten life of the electrical com-
ponents and is not recommended.
a regular basis.
4
Do not use gasoline, gasoline-type lantern
fuel, kerosene, charcoal lighter fluid or
similar liquids to start or “freshen up” a
fire in this stove. Keep these flammable
liquids well away from this stove when it is
in use.
Build-up of dust, soot, or creosote in the
chimney connector and in the exhaust vent can
cause a house fire. Although this will be
minimal with correct operation, it is advisable
to inspect the chimney connector and exhaust
vent on a regular basis and clean if necessary.
Ashes removed from the stove may be
hot. Ash must be deposited in a metal
container with a tight fitting lid. The
closed ash container should be placed on
a non-combustable surface and the ash
should be cold pending final disposal.
7’ to 8’
100

Related product manuals