Initial Start-up
Turn stove on, press enter button twice and SB will show in display box. Turn stove off and let
it go through shutdown. At conclusion of shut down stove will return to SB mode now you can
program.
Stove can be run in a manual or Time Mode (TM).
1. To run in manual mode press on/off button and stove can run manually.
2. At start-up stove will read ST/21. ST stands for start-up and 21 is start-up time. During
start-up only the auger and combustion fan come on. Convection fan comes on 20
minutes after start-up. You now have control of stove.
3. Digital readout will read ON (for manual).
4. Under the ON is a number that reflects the fire intensity. The setting can be from 0 to
100. O being the lowest setting and still have the stove running.
5. Set these with the plus and minus buttons.
If stove needs to be turned off push on/off button and stove will go through shut down mode.
When SB appears in digital readout shut down is complete.
Time Mode
In TM mode the stove can be set to come on at programmed times. You can set 2 programs
per day, and set heat intensity as well.
1. From SB push menu button.
2. MO(Monday) shows up in digital display.
3. Press enter and S1 is displayed and a number is displayed under S1. The number
under S1 is the time (displayed as a 24 hour clock).
4. Press the ‘plus’ or ‘minus’ button to adjust start time. Time can only be set to come on
in hourly increments and off in hourly increments.
5. Press enter and E1 is displayed. This stand for end of 1
st
heating period.
6. Press enter again and S2 is displayed. This for the second heating period. Set as in
S1.
7. Press enter and E2 appears. Set end time as in E1
8. Press enter and display returns to MO
9. Press Menu and the next day (TU) will appear. Program according to needs. Do this
for the remaining days.
STARTING PROCEDURE
21
To Next Page
Loading...