Austroflamm Ruby - Advanced Operation; APP and Smartphone Operation; IR Remote Control Operation

english 4
Stove operating status
Target temperature
Error
Warni
ng
Timer active
Temp. unit
Home screen
Tank level indicator
Current
room temperature
Delay timer
Menu with
heat output setting
Smart Spot is
connected
3 Initial Operation, Using the Stove
First steps:
1. The stove must be connected to the flue. There must be a sufficient supply of combustion air.
2. Remove the accessories from the pellet hopper and the firebox. Fill the hopper with pellets and close
the hopper lid.
3. Plug in the power cable and set the toggle switch on the back of the stove to "I ".
4. The display will now show the Austroflamm logo. This is followed by the main operating menu with tem-
perature indicators and hopper level.
5. Before the initial start, it is necessary to fill the pellet screw conveyor. For more detailed information, see
section "Menu item: Manual pellet feed" below. This process can take up to 5 minutes.
6. To start the stove press "Start" on the display.
3.1 Operating the stove via touch display
Display − Room temperature indicator, various functions
By pressing the appropriate symbol, it is possible to switch to the desired setting or function.
The desired temperature can be set by pressing the buttons at 0.2 °C intervals between 5 °C and
40 °C. The setting is accepted immediately. The current room temperature is measured Standard
necessary
by the black, room- temperature sensor cable on the back of the appliance.
The warning or error icons appear only when a warning or error is detected. The error is displayed in
detail by touching the icon.
The icon "Heating time activated" is only displayed if heating times are programmed in the timer menu.
The optionally available SMART SPOT - a radio-controlled thermostat - works in the stove.
OFF
Room temp.