Picking up the handset the communication starts off, and it is possible to:
• Open the door (³).
• Pass the call through to the flat (Æ).
• Perform a consult to the flat (Å).
• Readdress the call and pass it through to another flat (OK + search + Æ).
• Readdress the call and perform a consult to another flat (OK + search + Å).
Figure 4. Call from panel to a flat.
Call with an invalid code (Call to Switchboard ):
• Any code typed on the outdoor panel that hasn’t been loaded in the database of the
switchboard will be understood as “Call to Switchboard”:
• On screen the number of the calling panel will be shown and also the
identification of Phone/Monitor 0, and of SDL 0 (see figure 5).
• The call is managed the same way as another one, but it couldn’t be passed
through to a flat directly (using of code 0 is not allowed for phones, monitors or
SDLs). It is necessary to readdress the call to a flat in the database to pass it
through, or to perform a consult.
Figure 5. Call from panel with an invalid code (Call to Switchboard).
auta
Cod: 030101 P: 1
Pedro Martínez 1º C
Calling to
( OK Change
Å Æ Pass to
auta
P: 1 m/t: 0 SDL: 0
Calling to
( OK Change
Å Æ
To Next Page
Loading...
