installation and operation manual
OV-G-F: 50.3-52.0Hz (60.3-62.0Hz)
UV-G-F: 47.0-49.5Hz (57.0-59.5Hz)
Press UP/DOWN keys to scroll through these values
Presss ENTER key to edit the selected value
Press UP/DOWN keys to change the selected value
Presss ENTER key to save and return
Press ESC key to cancel and return
WARNING! Set GRID ON (see below) before new standard
is activated.
WARNING! Please note that the User-Def standard is not to
be used without the agreement of the local grid authority.
Press UP/DOWN keys to cycle through grid ON/OFF options
Press ENTER key to save
Press ESC key to return
Reset the inverters total kWh output to zero.
Change the password to enter Advanced Info and Advanced Settings.
7. Monitoring setup and system registration
The instructions about monitoring setup and system registration can be found in separate manuals enclosed in
the documentation that came with this Autarco system. For more information, please contact your Autarco
installer or refer to the downloads page of our website www.autarco.com.
8. Maintenance
The MX-series inverters do not require regular maintenance. However, impurities such as dust and dirt
accumulation on the heat sink may negatively affect the inverter’s ability to dissipate heat. Any dirt or dust can
be removed with a cloth or soft brush.
CAUTION! Do not touch the heat sink when the inverter is in operation. Turn OFF the inverter
(see section 0) and allow for cooling down before cleaning.
CAUTION! Never use any solvents, abrasives or corrosive materials to clean the inverter.
To Next Page
Loading...
General